|
Finishing & Preparing the Master Plug
for Mold Making
Installing Line & Hookset Eyes
46. Your master plug body should now look like Fig. 38.
47. With a #7 Wire Eye; use wire cutters to cut off the long end of the wire shaft. Fig. 39.
48. Remove the brass dowell pin from master plug body, Use the moto tool & drill bit to ream (clean) the shaping wax from the dowell pin hole. Fig. 40.
49. Fig. 41. Is a cut-away (cut in half) view of the inside of the master plug body. Indicating the wire eye channels that were previously drilled. These channels will now be filled (one-at-a-time) with M&CC, and the wire eyes inserted.
50. Refer to page 11. For small batch mixing instructions. Fig. 42.
|