|
Wire Eye Alignment Beds (Completed)
77. Once again; allow the fresh M&CC applied to the wire eye beds cure to the firm rubbery B-stage. Use your sharpened pallet knife to immediately begin slicing away small portions of the M&CC over the wire eyes until the wire eyes are exposed. Fig. 81. & Fig. 84.
78. Do not attempt to cut away all M&CC in one cut; but remove very small amounts of the M&CC until the pallet knife touches the wire eye. Fig. 82. & Fig. 83. Repeat this procedure on all three wire eye positions.
79. Your new wire eye bed should look like Fig. 84. & Fig. 85.
80. Remove the master plug. Your completed left mold half should look like Fig. 87.
This concludes making the left mold half master plug cavity.
|